Liftgate project (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 15, 2005
Threads
322
Messages
3,082
Location
on stage
Website
www.barryhause.com
I preferred the clam shell design of the fj60 so when my rear window quit going up and down I decided to experiment with some lift gate mockups. This is my first attempt. It's not super pretty but it works and is lockable. I used some 1/4 plexiglas. It's lightweight and relatively cheap. I want to get a piece of auto safety glass professionally cut.

Phase one complete
Now to apply tinting , tighten the weather seals and install lift struts.

I want the final product to fit snug in the inset of the removable top.

image-2658397410.jpg

image-2658397410.jpg
 
the rear window motors are cheap, those corners of your mock up are going to let the weather in if you live in the cold like I do..

I'm not done. I will have it sealed pretty well. I am doing it mainly for the clam shell. I just don't care for the rear sliding window.
 

Users who are viewing this thread

Back
Top Bottom