Leaping Deers FJ45pb

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

More 45 cage pix

couple more pix from tonite
just about done
have not tied down behind dash Randy, could be done, usually just go straight to floor...trying to maximize room here, the 45 is tight
my truck's been over 4-5 times with this design FWIW
there are full 3/16 backing plates back there tho
sorry for the bad light
DSC_1381.webp
DSC_1382.webp
 
Are you going to paint the inside of the tub while it is all apart? The body looks like it is in pretty good shape, except for a little bit of surface rust: perfect candidate for Rhino Line:D

Cheers,

Josh
 
finished up
buckets mounted
Thanks Jason!
DSC_1386.webp
DSC_1388.webp
DSC_1399.webp
 
Yes - very nice work :beer:

And thanks for lots of pics
 
Kina that looks amazing!! i will give you $100 plus a shackle if you paint it pink
 
Wow, you are an artist. That is truly beautiful work.
 
down the back near the seats how did u mount it to the floor??? can u remove the cage when you take the roof of ???
 
finished up
buckets mounted
Thanks Jason!

I like the integration of the upper seat belt anchor into the roll bar. What was involved in mounting the bucket seats? I have a set that I'm wanting to put in my 78 FJ45, but I'm told that the seats are shaped differently from the back of the bench seat and don't fit properly against the back wall without some modification. And moving the seat mounts forward only move the driver closer to the steering wheel. What did you goes do to get those seats in there without compromising driving position?
 
down the back near the seats how did u mount it to the floor??? can u remove the cage when you take the roof of ???

there is a 1/4 inch thick plate there, bolted in, fully removable


I like the integration of the upper seat belt anchor into the roll bar. What was involved in mounting the bucket seats? I have a set that I'm wanting to put in my 78 FJ45, but I'm told that the seats are shaped differently from the back of the bench seat and don't fit properly against the back wall without some modification. And moving the seat mounts forward only move the driver closer to the steering wheel. What did you goes do to get those seats in there without compromising driving position?

seat are different, p/u seats mounts are narrower
removed sliding mech from bottom of seats and mounted on cross bars which were welded to original drivers mounts over tank
pass side made mounts out of old 40 legs and remains of sliding mech that was removed....
 
poor Logan has nowhere to sit
 
Build him a special doggy seat in the bed.
 
as always, amazing work kina:clap:
Jason that 45 is just plain bad ass
 
Thanks guys. I went to pick the truck up yesterday. Kina did a great job with the cage. Now I have to start planning on what the winter projects are going to be.
 
4" lift maybe:D
 
I still want to see a picture of the whole truck now that the bed is all done; any chance?

Josh
 

Users who are viewing this thread

Back
Top Bottom