Land crusier 100 Help wanted

[bergur]

Hello everyone. I just instaled rear absorbers in a land crusier 100,
And thay will not lift after instal. Can anyone help out ?Tahy are hydrolic

 

[PhrogsPhorever]

What type and manufacturer? What year cruisee? an AHC truck? A little info on the truck
and shocks themselves would help.

Sent from my iPhone using IH8MUD

 

[bergur]

hmm i dont know much about the car i am asking for a friend of mine that is not very good whit computers and such. But its a 2002 land cruiser 100 series. he was talking somthing about needs to take the air out if the system

 

[cruiser100]

Does it have an ACH - Automatic Height Control - system?

 

[bergur]

no dont think so, Ther or so buttons next to the automatic shifter. Hige low and off nothing heppens when we press them

 

[hks3sgte]

Make sure the doors are closed

 

[2000UZJ]

Did you install normal shocks instead of AHC? Were there lines attached to the shocks? Location of the vehicle? There are many variations to the 100 Series (V8, Diesel, Solid axle, IFS, AHC, etc)

 

[KlausVanWinkle]

You lose a lot of fluid when you replace an AHC shock (ask me how I know). If you replaced the shock with another AHC shock then maybe your fluid is just low. Check the AHC fluid reservoir under the hood in the passenger side corner by the windshield.

 

[bergur]

Ya we cheaked the fluid and filled it upp whit toyota shock fluid but it dosent go from the conteiner to the shocks

 

[KlausVanWinkle]

Ya we cheaked the fluid and filled it upp whit toyota shock fluid but it dosent go from the conteiner to the shocks

What about when you change the height settings. I'd think the pump would pull from
The reservoir and bleed the air out.

 

[bergur]

Nothing heppens when we press the higt buttons