Kooks Headers and Exhaust

[Kooksheaders]

Hi All,

We are new to the forum and are seeking a little assistance. We are finishing up our new Toyota Tundra headers and exhaust, and we are looking for a 5.7L Land Cruiser to test fit a set on. I am willing to offer these at a extremely low price, with a free install, and also a dyno run. We will run the truck on the dyno before the install and then after, to verify power and torque gains. If anyone is interested please email me at chris@kooksheaders.com

Thanks,
Chris- Kooks Headers and Exhaust
704-768-2263

 

[jamesurq]

makes me wish I had a 5.7 motor swap

 

[lt1fire]

where are you located?

 

[tgadd]

@Steelman - do you or Chris have a 5.7?

 

[uzj100]

Post this up in the 200 series forum.

When we built them for the 100 series, it made quite a difference.

 

[Kooksheaders]

We are located in Mooresville, NC. Right by the Nascar Technical School.

 

[lt1fire]

D'oh..... Should have known that I've driven by your place a few times.

 

[lt1fire]

Andy and Justus both have 200s in the charlotte area.

 

[lt1fire]

@shellb looking for a reason to drive to charlotte??

 

[angerhater]

you need to make some for an 80 with the 3fe.....then I'm your huckleberry

 

[Roxx]

Matt vitelli has a tundra.

 

[jfz80]

Was gonna say same about @Fort Knox but wasnt sure if it needed to be an LC as mentioned ?

Matt vitelli has a tundra.

 

[Fort Knox]

Yeah, I have a 5.7 Tundra, but a Land Cruiser...it ain't.

 

[Steelman]

@tgadd I wish... 4.7L in our 1st Gen Tundra's.