Knuckle rebuild video - final video in the series (1 Viewer)

[lshobie]

Hi Guys,

I've made the last hub/knuckle/brake etc rebuild video, go here to check it out:

Toyota Land Cruiser front Knuckle rebuild tutorial - YouTube

And these are some of the other videos in my series:

Video #1 Toyota front knuckle, hub, and brake service overhaul Video #1 Removal.

Toyota front knuckle, hub, and brake service overhaul Video #1 Removal. - YouTube

Video #2 Aisin Manual hub (free wheeling hub) rebuild Toyota Land Cruiser

Aisin Manual hub (free wheeling hub) rebuild Toyota Land Cruiser - YouTube

Video #3Land Cruiser rear brake service, shoes, drum, emergency brake adjustment

Land Cruiser rear brake service, shoes, drum, emergency brake adjustment - YouTube

Video #4 Land Cruiser rear hub/axle service, bearings, axle, seals, gasket etc

Land Cruiser rear hub/axle service, bearings, axle, seals, gasket etc - YouTube

Video #5 Slee Castor Correction Bushing install, Land Cruiser Tutorials.

Slee Castor Correction Bushing install, Land Cruiser Tutorials. - YouTube

Video #6 Land cruiser 1HZ 1HDT 1PZ Valve shim adjustment tutorial

Land cruiser 1HZ 1HDT 1PZ Valve shim adjustment tutorial - YouTube

Video #7 Warn 8274 winch rebuild series #1, disassembly of winch

Warn 8274 winch rebuild series #1, disassembly of winch - YouTube

Video #8 Warn 8274 Rebuild video # 2 Re-assembly of winch

Warn 8274 Rebuild video # 2 Re-assembly of winch - YouTube

 

[lulo]

Great VID`s!!!


... more, more, more, more, more, more, more


Thanks for your tutorials vids

 

[Firsttimer]

These videos are great!! Thank you!!

I've just completed rebuilding my passenger hub/knuckle.

A few quick questions:

1. How tight do you tighten the oil seal on the back of the knuckle (i.e. the one made of felt, rubber, and steel pieces)?

2. I didn't remeasure for the appropriate shims, but just put the original shims back - that's okay right?

3. I don't have a spring tension gauge. How important is it that I measure the preload?? What is the purpose of this??

Thanks in advance!!

 

[ForealBoreal]

These videos are great!! Thank you!!

I've just completed rebuilding my passenger hub/knuckle.

A few quick questions:

1. How tight do you tighten the oil seal on the back of the knuckle (i.e. the one made of felt, rubber, and steel pieces)?

2. I didn't remeasure for the appropriate shims, but just put the original shims back - that's okay right?

3. I don't have a spring tension gauge. How important is it that I measure the preload?? What is the purpose of this??

Thanks in advance!!

2) If they fit the correct tolerances. If not you need the correct sized shims.

3) Its important in the sense that you bearings will be either be too tight or too loose making them wear quicker than usual.

 

[Frankenstien]

Thanks for making these. Liked and Subscribed on Youtube.

Where did you get that force gauge?

 

[Blade]

I also uploded a video of the work I did with a friend in La Paz, Baja California. But it's a little bit faster than yours Louis!

https://www.youtube.com/watch?v=ZmrCOVf8wyk