KMC wheel question -Fitment

[WRO]

Has anyone ever put 17” KMC KM717 18mm offset on their 100 series, I have a 3" lift and they come with 315/70/17's tires. Just wondering on offset, spacers, and will they fit wheel wise.

 

[FxFormat]

That's a wide tire, i suspect you'll be hitting the corner of the lower front bumper unless you have a metal bumper, and it'll rub the plastic fender liner right infront of the pinch weld. UCA should clear with that offset. Don't use wheel spacers it'll make it worse

 

[WRO]

That's a wide tire, i suspect you'll be hitting the corner of the lower front bumper unless you have a metal bumper, and it'll rub the plastic fender liner right infront of the pinch weld. UCA should clear with that offset. Don't use wheel spacers it'll make it worse

Do you think that wheels will fit without spacers?

Wouldn't a spacer push them closer to the stock 60mm offset or am I wrong here.

*Note, I've been wrong once a bunch of times.

 

[FxFormat]

Do you think that wheels will fit without spacers?

That all depends on the hub bore's design, if it's 110mm all the way through then yes, it'll fit without spacers. Wheels like the KMC Addicts, that would will NOT fit the front hub because the bore is 110, but then it tapers down to smaller size for the centercap. Same with tundra rock warrior, it tapers down so those will need spacers. Best thing to do is pop the center cap off the wheel, and see if it goes straight through or does it get smaller.

 

[WRO]

That all depends on the hub bore's design, if it's 110mm all the way through then yes, it'll fit without spacers. Wheels like the KMC Addicts, that would will NOT fit the front hub because the bore is 110, but then it tapers down to smaller size for the centercap. Same with tundra rock warrior, it tapers down so those will need spacers. Best thing to do is pop the center cap off the wheel, and see if it goes straight through or does it get smaller.

Will do, it is a 110 bore, I have a call into KMC to see if its tapered or not.

 

[Tanner H]

18 offset with a 315 will fit after you do the normal pinch weld hammer and fender liner massage. Ideally the sweet spot is about a 30 offset with 315's which is essentially impossible to find. 18-15 offset seems to be the normal offset range for wheels that fit our 100's.

This guy is running 315/70/17 on a 17x8.5 with 15 offset. To give you an idea of fitment/poke.