Hello mud, hoping the land cruiser gurus can help me out. Just had a shop regear my axles and a couple days after, my front passenger side is making a grinding or groaning noise I’ve never heard before. It only does it after a few minutes of freeway driving and goes away. Abs light is on the dash after the noise happens. The noise happens randomly. Everytime I restart the car the abs light turns off until the noise happens again. Speed sensor was loose but tightened and check both sides.... is sounds and feels like wheel bearing but not sure... any ideas of what this might be? Thank you all for the help.
Just regeared and now front axle making noise (1 Viewer)
- Thread starter Smartzombie
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Dry spindle bushing.
Birf wobbles, hits the ABS sensor causing bad readings.
You need to take it back to the shop ASAP.
They may not have greased it appropriately either.
Birf wobbles, hits the ABS sensor causing bad readings.
You need to take it back to the shop ASAP.
They may not have greased it appropriately either.
They may have also torqued your spindle nuts to FSM, which has an error. It says the torque number in inch/pounds, it should be in ft/lbs.
- Thread starter
- #4
Thank you so much for your input. taking it back to the shop and will not drive it until then. Very disappointing. Thank you all again.
