Just how tall is my suspension lift anyway?

[ShottsUZJ100]

Hey....new thread. WooHoo!

I measured the distance from the top of my stock wheel to the inside of the fender. I got 15-inches on the dot. How much lift is that over stock? I can't find my old notes from when I put on the lift. I'll bet Christo knows.

 

[Newps]

I just walked out and measured mine and I got 11 inches.

 

[ShottsUZJ100]

Thanks a bunch. Ya, that's what I remember. Actually my measurement was 14 15/16" so that works out to 3 15/16, well...4-inch lift. Thanks again.

 

[Newps]

I was reading your discussion on the other thread. Did you lower your bump stops to in order to run the 35's? If so how much?

 

[ShottsUZJ100]

Yepper. I cut 2x2x6 inch steel and used it between the stock stop and the frame. Took 30 minutes. Between the 35's and the L-series shocks I wanted to make this change to protect the tires. It cuts on your flex a bit though I can't really tell because this thing's such a billy goat any how. No front rub whatsoever. Wow, I wish they had L-series shocks for the 100!

 

[ShottsUZJ100]

Need to clarify. Only lowered the rear stops. The front's are fine despite the L-series shocks.

 

[Newps]

I cut 2x2x6 inch steel and used it between the stock stop and the frame.

How much did this equate too? One or two inches?