Is my crank pulley weird (7 Viewers)

[Chester White]

I’m in process of doing my timing belt, etc. on my 2000 Landcruiser. By all accounts, people recommended getting the Schley tool 64300 to control the crankshaft pulley when removing it, as opposed to using a chain wrench. I got the tool. It has bolt slots 65 mm apart. My pulley’s pretapped holes, which are the correct bolt size, are 3” or approximately 75 mm apart, so the tool won’t work. Has anyone else run into this? Recommendations please!

 

[Chester White]

Update. I held up my phone and took another picture, straight on. It turns out that there is another set of 8-125 holes, 65 mm apart on the pulley. Problem solved.