LowBudgetLX470
2000 LX470 with 300k+ miles
I have searched here on Mud and other web resources. I understand how to jumper the terminals in the OBD1. BUT…. Which terminals do I jumper for a US based 2000 LX470 to retrieve codes for ABS / VSC?
I’m hoping to identify a faulty wheel speed sensor. I have checked the ohms on the front wiring harness and checked the spinning volts on them as well. I haven’t checked the rear because I haven’t found where their disconnects are.
One resource suggested to jumper Ts and E1. I did that, AHC off light flashed rapidly and continuously. I could not see any other light flashing in a code like manner.
Another resource suggested to jumper Tc and E1. The AHC off light gave me code 62. That was a problem I was aware of already. But it confirmed what I thought about that issue.
I looked at the FSM linked here on Mud but either couldn’t find or did not understand any information on which terminals to use for this specific diagnostic procedure.
Please help.
I’m hoping to identify a faulty wheel speed sensor. I have checked the ohms on the front wiring harness and checked the spinning volts on them as well. I haven’t checked the rear because I haven’t found where their disconnects are.
One resource suggested to jumper Ts and E1. I did that, AHC off light flashed rapidly and continuously. I could not see any other light flashing in a code like manner.
Another resource suggested to jumper Tc and E1. The AHC off light gave me code 62. That was a problem I was aware of already. But it confirmed what I thought about that issue.
I looked at the FSM linked here on Mud but either couldn’t find or did not understand any information on which terminals to use for this specific diagnostic procedure.
Please help.