Time for a new floor jack. I'd like to get one that's stout and can handle a lifted truck. Any recommendations for or against any in particular?
Floor Jack Recommendations (1 Viewer)
- Thread starter T4Runner
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I pick up a 6 ton one at harbor freight that had the highest throw I could find. I'll post a pic of it when I get home. Not an easy thing to find when you have a lifted vehicle.
It's a 4 ton not 6 my bad
- Thread starter
- #4
Thanks!
Markuson
SILVER Star
Just a random safety thought... but I'd probably want to set a couple of strong blocks or wheels under key points just in case a jack were to fail while I'm under my beast in the garage... 
Agreed. Got these when I picked up the jack. These are the 6 ton
I too have a Pittsburgh like Willy. Mine is a 3 ton, low profile. I am pleased. Amazon.com: 3 Ton Heavy Duty Ultra Low Profile Steel Floor Jack with Rapid Pump Quick Lift: Home Improvement
I have the 3 ton version of this jack. I'm not sure why I didn't get the 4 ton...perhaps because the extra 30lbs makes it a pain to pick up? Or I just didn't see it.
4 ton: min 4", max 20 1/2", weight 99.9lbs
3 ton: min 5", max 18 1/4", weight 68.9lbs
I've been watching for Hein-Werner long frames on craigslist for a few months. Easier to find a 10 tonne than a 4 and while the lift height is nice I don't really want to drag around 430lbs. @DawnC and I have run out of capacity AND lift height with suspension work on our normal jacks.
25 3/4" / 65cm max lift height:
Hein-Werner Automotive Professional Hydraulic Service Jack 4-Ton Lifting Capacity, Model# HW93657 | Floor Jacks| Northern Tool + Equipment
@arich you have swapped out your suspension many times. What do you use?
25 3/4" / 65cm max lift height:
Hein-Werner Automotive Professional Hydraulic Service Jack 4-Ton Lifting Capacity, Model# HW93657 | Floor Jacks| Northern Tool + Equipment
@arich you have swapped out your suspension many times. What do you use?
Look at the AC Hydraulic DK20HLQ. Lifts 4400 pounds to 31.5". Link: Pelican Parts.com - High Profile Hydraulic Floor Jack
I have two of these and they are by far the best jacks that I've ever owned; relatively low profile, long reach, high lift and fully serviceable components. They lift my LX570 with ease. Relatively expensive at $750 but you will not be disappointed.
I have two of these and they are by far the best jacks that I've ever owned; relatively low profile, long reach, high lift and fully serviceable components. They lift my LX570 with ease. Relatively expensive at $750 but you will not be disappointed.
How smooth and precise on the release? Does the D handle turn for this part of the operation or a different mechanism? How are rebuild kits? Really a great price for an EU made hydraulic IMO.
The release is thru the D handle, simply pull up on it about 1" and twist CCW to open the valve. You can easily control the decent rate of the load anywhere from very slow to fast by varying the amount of 'twist' of the handle. It can easily be done one handed.
I have had the jacks for several years and have not needed to perform any service other than occasional inspections so I cannot answer your question regarding a rebuild. Mine see regular home garage use and I have yet to see any drips or weeping seals on the cylinder nor experience any sag/droop when the load is lifted and stationary.
