Wanted FJ60 Manual (59 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

New 29.00 part no, 14038632 GM call your local GM dealer



Butch
 
ttt
 
80 series front mud flaps wanted

Anyone have a set of front factory mudflaps for an 80 laying around? Took the steps off my wife's truck, but wanted to get flaps while I'm saving up $$ for lift and sliders. Thanks.
 
Less than 100 bucks from Cruiserdan.
 
lcruzrlvr said:
Mike.. You have PayPal.

Thanks for the help.

Troy

Got it, will ship on Thursday, didn't have it with me at work.
 
doooooh! sorry about that steve. i know you had asked me about them a while ago and i completely spaced out. i assume you're looking for the 2wd cover, not the cast aluminum 4wd version.
i have the 2wd plastic one i will send you for nutin if you still want it. need your addy though.
 
hey mike.
do you need the 4 bolt plastic (or stamped sheet metal) 2wd cover or the 6 bolt cast aluminum 4wd cover?
i should have the right 4wd cover if that's what you need. :)
 
HHM I did not think about the cast aluminum, this is the stamped steel one.
Poser is being vague......
Butch
 
it's a4 wd version. I think it has 6 bolts. Don't have one, bougt a built tranny, no cover.
 
62/60 Tire Winch and Bottle Jack

Looking for a toyota bottle jack and spare tire winch for an '88 62. I assume a 60 winch is the same as the 62???
 
can you post a pic of the bell housing where the cover attaches? there are 2 different styles. i should have either one for you.


cost?! how about a raffle prize for this year's "fj45 run". ;)
 
60 Dash Cubby

I need the storage compartment where most people put a CB....

Right under the radio opening....

Anybody have one to sell?
 
Used lift springs

Hey I'm looking for a cheap set of used leaf springs that'll provide 2.5 to 4 inches of lift. Shackels too if possible

Thanks
Brandon
 
need front seat brackets fj40

1978 fj need small floor brackets at the rear of the front seats

thanks
 
Looking for ARB Bull bar for 80series

I am interested in getting an ARB Bull Bar (winch or non-winch) for an 80 series.
 
80 Series Factory running boards

I'm looking for factory running boards and cap with all the hardware. Running boards must fit 94 landcruiser.
 

Users who are viewing this thread

Back
Top Bottom