SOLD FJ40 9 Pin Hazard Switch with melted wire(s)

[BeerM3]

Location

United States

I didn't feel like trying to resurrect this part, so I'm offering it up to anyone that might want to cover the shipping cost. I believe $7 ships it anywhere in the US via USPS Priority.

The PO put a 40 amp fuse in one of the fuse panel spots and I suspect that's why I had a melted green yellow wire in the harness I had to replace. It appears to have heated up one or two pins inside the plug housing to the point where they melted and pushed down into some of the plastic around them.

The shrink wrap is still on the outside and it feels/looks to be in good shape otherwise. I didn't open it up to check the circuit board inside. It may be junk, but rather than just throw it out I thought I'd offer it up here first. It came out of a 1/76.

 

[Beachcomber Bernie]

Sounds like fun.
PM incoming

 

[65swb45]

@RAGINGMATT could make that like new again.

 

[BeerM3]

"sold" to Beachcomber as soon as we get the shipping and address sorted out. I'll reply to your PM.

And thanks Mark. I remember now @RAGINGMATT had replied to another thread of mine. I think it was the ISO request for the replacement I found. I forgot he was an electrical guru. I'll keep that in mind if I find something else fried.

 

[65swb45]

"sold" to Beachcomber as soon as we get the shipping and address sorted out. I'll reply to your PM.

And thanks Mark. I remember now @RAGINGMATT had replied to another thread of mine. I think it was the ISO request for the replacement I found. I forgot he was an electrical guru. I'll keep that in mind if I find something else fried.

That's what the like button is for.