Hey all,
Bear with me here. I am thinking about a fender-mounted antenna for HAM on my 200-series, and wondering how you typically route the cable. The panel gap between the hood and the fender on the 200-series is amazingly tight -- like on the order of 1/8"/0.125". With even the thinner RG-58 feedlines measuring over 0.2" diameter, I don't think I can run the cable under the hood. Anyone else had this issue? Should I try to run it up the top of the hood/by the windshield "vent"?
THX!
Bear with me here. I am thinking about a fender-mounted antenna for HAM on my 200-series, and wondering how you typically route the cable. The panel gap between the hood and the fender on the 200-series is amazingly tight -- like on the order of 1/8"/0.125". With even the thinner RG-58 feedlines measuring over 0.2" diameter, I don't think I can run the cable under the hood. Anyone else had this issue? Should I try to run it up the top of the hood/by the windshield "vent"?
THX!