Dana 60 cap bolt dimension

[Cruisertime]

Anyone know the dimensions to the four bolts? Sitting in hardware store parking lot. ......

 

[LC_Hamma]

1/2" X 13 X 2" long

 

[Poser]

Which cap?


Carrier bearing?


Knuckle?

 

[LC_Hamma]

I assumed bearing... The stock driver knuckle uses dbl. ended studs & if he just wants to use 4 bolts for the right side, the size is 1/2" X 20 X 3/4".... ;p

 

[Cruisertime]

1/2" x 20 was the winner. ...... I just bought all the everything from 3/8 to 5/8 .... I was asked to pick up some bolts for a highsteer project.

 

[Mad4wd]

I was asked to pick up some bolts for a highsteer project.

Ummm... are you talking about the studs that go into the knuckle? If you are...depending on the arm you are using...thes may not work correctly. Factory D60 studs have shanks larger then .500".

Lar