cut or not cut

Discussion in '40- & 55-Series Tech' started by eg40, Aug 11, 2005.

  1. eg40

    eg40

    Messages:
    12
    Likes Received:
    9
    Joined:
    Aug 11, 2005
    I am in the middle of putting in a 350 sb chev 7004r trans and stock t-case. I have the bob firestine motor mounts. question is when I jack the drive train up in to what I think is the right spot it hits the body. I think it could even go up a little more. the trans pan is 1/2 inch above the bottom of the frame. So is that about right or do i cut the body to make more room for the t-case? it is a 72 fj40
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.