Cut and Turn (1 Viewer)

[77landsitter]

Do any of you guys know of anyone who would be interested in doing a cut and turn on a 78 front housing for me? I plan on going SOA very shortly but the cut and turn process is standing in my way. Looked into proffitts kit but it seems like a pain to ship out to Colorado. I'm located in Easton PA you can reach me at 610-360-9549.

Thanks,
Dan

 

[blackandbluefj]

that was the easiest part of my soa in my opinion. The biggest fear i had was the first cut. Just take it slow and use the angle grinder with the cutoff wheel. Just make sure to measure i went to a quarter of an inch andit was a tad too far just use a big pipe and breaker bar to turn it and do it on the truck. Let me know if you have any other questions just dont sweat it


good luck


Bryon

 

[mls57jax]

Dan,

PM sent.

Mike in PA