Cummins Rough Idle

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

sending the injection pump for rebuild, the doge guys took it off and there was about 3/16 back and forth play on the main shaft (not side to side)
 
That's a tough one. Sometimes it is better to just buy a reconditioned IP. Your final cost depends on the amount of parts that need to be repaired. They won't be able to tell you until they have the IP apart and tested for tolerances. Hope you get lucky and end up with a cheaper rebuild.

BTW, who are you getting to rebuild it?
 
sending the injection pump for rebuild, the doge guys took it off and there was about 3/16 back and forth play on the main shaft (not side to side)

When I got it back from the rebuild there was no play in the shaft, dodge guys put it in an it idle's fine

Just thought I would finish this off if anyone else has this problem with their cummins.

:beer:
 
ya it hurt a bit, but I use the truck for work, so a couple trips to Fort Nelson would pay for the rebuild
 
Sorry about the price, A good fuel conditioner will keep the next pump alive much longer
 
Back
Top Bottom