Is there such a thing? I just built a tool to hold the crank pulley for an FZJ80. I would be willing to get it down to Kevin or whoever would want to keep such a thing down there for the majority of the club to use.
CSC Loan a Tool Program (1 Viewer)
- Thread starter MoGas
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Very Cool Looks well built
Thanks Dave
Thanks Dave
That is one stout looking tool, thanks for offering it up loan.
To go along with Dave's crank pulley tool, I have a MATCO torque wrench, 3/4 inch, 100-600ft/lb that is available for loan to club members.
Thanks,
Greg
To go along with Dave's crank pulley tool, I have a MATCO torque wrench, 3/4 inch, 100-600ft/lb that is available for loan to club members.
Thanks,
Greg
Is that a torque wrench in the last pic? Looks interesting.
- Thread starter
- #5
So now all someone would need is a 3/4 drive 30mm socket.
- Thread starter
- #6
THAT I could get a use or two from.
I have a few SST's, front and rear bearing nut sockets and various others I disremember at the moment, available whenever.
- Thread starter
- #8
Phil, I will be in the 'Dale on Tuesday. Could I drop it with you for safe keeping?
Drop it in the driveway locker anytime
32mm for the SC owner.
I have a cheap set of harbor freight 3/4 inch drive sockets with 30mm and 32mm available available for loan with the torque wrench.
Its yours anytime you need to use it.
- Thread starter
- #13
I didn't get the time to drop it off over at Phil's. I'll be down again Friday evening. Maybe I can drop it then.
- Thread starter
- #15
I didn't take it down yet as I ended up still needing it. I need to meet up with Murph about some wheels, so I should try o get down that way. If you are in dire need, I can ship it directly to you.
LMK,
Dave
LMK,
Dave
more tools
I have a socket that i made to tighten the rear bearing nut on 96 FJ80 axel... i also have a set of dies to press the bushing out of the front radius arms.
I have a socket that i made to tighten the rear bearing nut on 96 FJ80 axel... i also have a set of dies to press the bushing out of the front radius arms.
I have a socket that i made to tighten the rear bearing nut on 96 FJ80 axel... i also have a set of dies to press the bushing out of the front radius arms.
Hey Swowie, Nice to hear from you
Very nice job on the rear hub socket
- Joined
- Jul 20, 2004
- Threads
- 274
- Messages
- 23,233
- Location
- Chandler, AZ
- Website
- www.tontorecreationalliance.org
Hey Swowie, Nice to hear from you
Very nice job on the rear hub socket
X2, been a longtime!
- Thread starter
- #20
I dropped off the crank tool with Murph this morning.
