Mauser
Supporting Vendor
I just installed the Ironman 2.5" lift on my wifes 2005 GX470.
After aligning it I took it for a test drive and got the 2 VSC lights and the slip indicator. I went back and connected Techstream and I needed to do the zero point calibration. I erased the memory then went to the test mode and ran it. I no longer had the ZPC code, but now have a C1234 indicating that the yaw rate sensor is not functioning correctly. I have tried erasing the memory and also erasing the code, but it won't go away.
Could this code be caused by me stretching the abs/speed sensor wires? I don't know if I did or not. I tried not to.
Anybody have any ideas?
Thanks
After aligning it I took it for a test drive and got the 2 VSC lights and the slip indicator. I went back and connected Techstream and I needed to do the zero point calibration. I erased the memory then went to the test mode and ran it. I no longer had the ZPC code, but now have a C1234 indicating that the yaw rate sensor is not functioning correctly. I have tried erasing the memory and also erasing the code, but it won't go away.
Could this code be caused by me stretching the abs/speed sensor wires? I don't know if I did or not. I tried not to.
Anybody have any ideas?
Thanks