Hi Guys,
I was removing my running boards a couple of nights ago. Things were going surprising quick (thanks to some PB Blaster) until the middle stud snapped off.
If you remember, 5 bolts hold the boards on, and 1 bolt is welded with a nut that comes off.
Now, I am scheduled to get my new sliders from Slee on Friday and I am not sure about this. Would my best bet be to try to drill out the remaining broken bolt? Could I just match one of the existing bolts and use that?
Could I access the other end of the broken bolt?
Thoughts ideas suggestions appreciated...
Also, I am a kinda guy with kinda guy tools.
Thanks
Rob
I was removing my running boards a couple of nights ago. Things were going surprising quick (thanks to some PB Blaster) until the middle stud snapped off.
If you remember, 5 bolts hold the boards on, and 1 bolt is welded with a nut that comes off.
Now, I am scheduled to get my new sliders from Slee on Friday and I am not sure about this. Would my best bet be to try to drill out the remaining broken bolt? Could I just match one of the existing bolts and use that?
Could I access the other end of the broken bolt?
Thoughts ideas suggestions appreciated...
Also, I am a kinda guy with kinda guy tools.
Thanks
Rob