Nice surprise taking the bolts out of my hub cover- two broken bolts that had been “glued” back in.. ideas or tricks on getting the rest of the bolts out of the hub body?
Broken bolts in hub (1 Viewer)
- Thread starter OzarkMtnCruiser
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Standard broken bolt removal techniques.
If that fails - there's alway$ the new option:
If that fails - there's alway$ the new option:
Aisin Locking Hubs Land Cruiser (FJ60 / FJ62)
Factory new AISIN FJ60 locking hubs. Gold dials are factory on all 60 and 70 series Land Cruiser 1979-1990. Genuine Aisin. Made in Japan.
www.yotamasters.com
Some screws broke in my FJ62's hubs. The screws ended up coming right out of the hub with very little effort from what I remember. A left hand drill bit would probably drive the broken stubs right out.
- Thread starter
- #4
That's probably the only way considering the diameter of these bolts- Hopefully i can use a punch to make a center mark, i'm sure they are broken off flat? I'm going to soak them in some PB, one of the bolts is barely stinking out above the hub, i might be able to get a vice grip on part of it and twist it out... but the other one is in there-
- Thread starter
- #5
Saw that, thanks. Hopefully it won't come to that!Standard broken bolt removal techniques.
If that fails - there's alway$ the new option:
Aisin Locking Hubs Land Cruiser (FJ60 / FJ62)
Factory new AISIN FJ60 locking hubs. Gold dials are factory on all 60 and 70 series Land Cruiser 1979-1990. Genuine Aisin. Made in Japan.www.yotamasters.com
