Brake Proportioning valve (1 Viewer)

[PKP80]

Does anyone have/know the link that shows how to adjust the proportioning valve after OME lift? Thanks in advance. DID a search and didn't find anything with directions.

Sam

 

[Rookie2]

I don't recall seeing any specific directions on the "how-to" adjust the LSPV. Mostly just discussions on the "need-to" after a lift. I would think there'd be some how-to in your FSM. IIRC you basically want to lenghten it the amount of the lift.

 

[Bear80]

I've found that you don't lift it the same amount as the lift. On my mini I raised the mount by about 1" for a 2" lift. On the 80 I adjusted the mount to the top of the stud, which was about 1/2" higher than the stock location. I did this through trial and error. I used my CDL to diable the abs, go out and lock up the brakes, then if the back locked first, go and adjust, if the front locked to early, adjust. This took about 3 days to get right.

 

[SR.GRINGO]

I pushed the valve down about a 1/4 inch--a little less--it is now at the bottom of the bracket.

 

[clownmidget]

http://www.lcool.org/technical/80_series/brake.html

 

[tarbe]

Does anyone have/know the link that shows how to adjust the proportioning valve after OME lift? Thanks in advance. DID a search and didn't find anything with directions.

Sam

Go here: http://www.sleeoffroad.com/newbie/newbie100.htm

Go way down to section 5.8

 

[corbs]

Search for LSPV

 

[PKP80]

Thank you all....you're awesome for the help.