Bone Yards in Phoenix

[azTony]

I am looking for driveshafts to replace my stock shafts to DC shafts and am looking for Junk Yards in Phoenix. I could call all over but wanted to see if anyone had preference and/or good luck with any particular yards. I will also be looking for a good shop to do some shaft work for me to cut and balance them. I appreciate your suggestions.

 

[Ray K]

Balancing

I once could recommend a couple of good junk yards since I worked at them. Now it's called Tempe Marketplace. For balancing, try King Balancing in Glendale. Not sure if they do driveshafts but they've been balancing engines for over 40 years and I'm sure could point you in the right direction if they can't do driveshafts.

 

[Tools R Us]

Check this thread for drive shaft shops.
https://forum.ih8mud.com/az-copper-state-cruisers/366519-recommend-driveshaft-shop.html

 

[inkpot]

Howdy! When I did both of mine at Mesa Driveshaft, I just carried in my stockers, and they supplied the correct DC for both. Unfortunately, they did not have a long slip joint for my setup. John

 

[grrlscout89FJ62]

I stumbled across this place's website a while back. Once, when I was over on that side of town, I went looking for it, but had no luck:

Toyota Used Parts, Toyota Salvage Parts, Nissan Used Parts, Nissan Salvage Parts- Toyota Salvage Yard

 

[Rudster]

About 6 weeks ago Toyoata Salvage had 2 - 80 series. I went down there . One was I believe a 91 but was pretty much stripped of everything and the other was a 95 and they just had gotten that in so some parts were missing..I would be curious as to what is still left on the 95. I manage to get a few parts off of the 95.

 

[azTony]

Thanks for the tips but both lead me nowhere. I am getting some nasty noise when I decelerate and with the 850's in front and 2" Metal Tech spacers I will need the DC shaft and hope this gets rid of my noise.

 

[enterconnect]

Diamondback auto has a 94. Or you can buy this Toyota Land Cruiser - 1991 and get all kind of parts.