Basic Prinsu Question

[Idaho Savage]

I'm about to attach some stuff to my new Prinsu and I'm wondering what people are using nut-wise to attach things to the bar. Seems like there are a few options, i.e. nutserts, flat nuts, etc.

Any info is appreciated to avoid multiple trips to the hardware store. First up is a rigid 40" bar.

Thank you in advance.

 

[radman]

I'm about to attach some stuff to my new Prinsu and I'm wondering what people are using nut-wise to attach things to the bar. Seems like there are a few options, i.e. nutserts, flat nuts, etc.

Any info is appreciated to avoid multiple trips to the hardware store. First up is a rigid 40" bar.

Thank you in advance.

1/4” carriage bolts. They fit into the slots, and the square neck below the rounded head prevents it from spinning. Then, you have your choice of nylock, nut with locking washer, or butterfly nut at the other end.
I used the prinsu light bar mount to attach my 40” adapt.

Post in thread '2015 LX570 Prinsu Rack Install'
2015 LX570 Prinsu Rack Install - https://forum.ih8mud.com/threads/2015-lx570-prinsu-rack-install.1169712/post-13040095

 

[Idaho Savage]

Thanks @radman . Knew I should have ordered the load panels. I did order the light bar bracket but Prinsu/CBI has yet to ship it because something else on the order was out of stock and their Customer Service is non existent.

Very much appreciated.

 

[Cruisin911]

I'm using 1/4" for everything on mine. Sorry to hear about the light bar bracket as that is what I am using for mine. I just had ended up calling them and they pushed it through. This was pre-Covid though.