There is a thread that for hours of searching I can’t find. I thought I had saved the page but apparently not. There’s a guy on there that mounted an Xtreme Blast air horn on his GX. Just looking for his thread so I can see how he mounted the motors. Thanks gents.
GX - 2nd Gen (2010-2023) - DIY GX460 #Air #Horn - A quickie write up here as I may be the only one here to do this. Almost side swiped a couple of times on the highway and the stock horn seems to get a slow reaction. https://www.youtube.com/watch?v=52Jc2YRe-VE...
GX - 2nd Gen (2010-2023) - DIY GX460 #Air #Horn - A quickie write up here as I may be the only one here to do this. Almost side swiped a couple of times on the highway and the stock horn seems to get a slow reaction. https://www.youtube.com/watch?v=52Jc2YRe-VE...
Something I've wanted to do on several of my previous vehicles and this GX also.
Although, considering I already have the ARB dual compressor, I think I only need an air tank and horns.
Been thinking about designing some horns and 3D printing them, and for the tank, just use some SCH 80 PVC.
A short section of 6" SCH 80 PVC is good for 280 psi at 73° F and even at 140° F still hold over 220 psi. A foot long section will hold almost 340 ci of air.