Adding Boost Compensator to 1HZ (4 Viewers)

[likethewheel]

Found (what I think is) the correct EPC schematic … I see the gasket and bolts I need but do I need any other small parts in order to bolt this compensator (22540-17260) onto my injection pump (‘93 HZJ75)?

Injection pump body for Toyota Land Cruiser HDJ81V - Genuine parts

Injection pump body for Toyota Land Cruiser with HDJ81V

toyota.epc-data.com

Gasket (1): 22774-54270
Bolts (4): 22395-54010

Appreciate any insight!

update: I actually bothered to look at the injection pump and the BC and realized in doing so that the gasket and bolts can be re-used. Now, my question is: how difficult is it to attach the BC to the IP? Does anyone have a write up or is it so straight forward as to not even need instructions? I'm fairly mechanically inclined and it looks like it could/should be pretty straight forward ... a few here have mentioned having done this on their rigs so I'm hoping someone can chime in. FWIW, I have a freshly rebuilt IP sitting on my bench, which should make installing the BC a fair bit easier than trying to do it with the IP installed on my rig.

 

[svsisu]

There is a lot of good info in this thread Re adding turbo and boost compensator:

Builds - 1985 BJ70 Story and Modifications

forum.ih8mud.com

Hopefully that helps you some

 

[likethewheel]

There is a lot of good info in this thread Re adding turbo and boost compensator:

Builds - 1985 BJ70 Story and Modifications

forum.ih8mud.com

Hopefully that helps you some

This is perfect—thank you!