94 FZJ needing new exhaust system
- Thread starter WFCruiser
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
i know a couple rdu folk have been pleased using Henry's muffler shop in RDU
little_joe i think, mtbcoach, southern cruiser62 and a few more have had theirs done there
www.henrysmufflershop.com
little_joe i think, mtbcoach, southern cruiser62 and a few more have had theirs done there
www.henrysmufflershop.com
Yup, Henry's has done 3 exhausts for me, always reasonable and routed as requested. I use the Millbrook shop, Donnie is the Mgr...
just make sure you tell them you will be wheeling the vehicle and to tuck everything up. when brandon went over there with his 95' 80 the mounted his o2 sensor facing down. They did a good job on mine, but i did tell them what i wanted.
Would one from a 95 work?? I've got a custom one off of a 95 sounded and flowed really well. I will sell for very cheap to get out of garage. Has 2 fairly new o2 sensors cats and muffler
95 is different. O2 sensors are not going to work, 95'=MAF and the 94'= Speed Density.
the 94' has left/right trim obd1 o2 sensors.
the 95' has fore/aft ODBII o2 sensors.
the 95 exhaust on a 94 wont work unless you move the o2 sensors up to the down pipes.
the 95' has fore/aft ODBII o2 sensors.
the 95 exhaust on a 94 wont work unless you move the o2 sensors up to the down pipes.
Yeah I thought there was a difference somwwhere
He had them on hand when I had my 80 exhaust re-done, yet, I'd call ahead just to give him a head's up...
he might not have any o2 sensors for the odb1 vehicles. check with roxx he might have some used ones from a 94'. toyota sales the o2 sensors as a kit, *** in fact there was a recall for the 94', i would check with the toyo dealer and see if they were replaced. if they weren't the recall is still valid, and you can get them installed free. ... also you can order the o2 bungs (slee or ipor) online and install the o2 sensors about any where you like. if you are not in a hurry magna flow has some nice hi-flow cats that tuck up out of the way like these. http://www.summitracing.com/parts/mpe-59906/overview/ i don't rember if the pipes are 2.5" or 2.25". i think would be a better option then the generic cat's they sell.
OB-1 had the exhaust redone by someone here in charlotte. You may want to contact him for details.
Last edited: