For Sale 83 Turbo 3B FJ60

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Location
United States
Selling the FJ60. It has a KKK turboed 3B installed. Also an Audi intercooler. Boost, EGT and oil pressure gauges, factory BJ dash with tach. Manual glow switch and Pto cable to shut down (no EDIC). Brand new AISIN clutch, pressure plate, pilot bearing and throw out bearing. Head replaced about 5,000 miles ago by PO. Motor runs excellent! Also has ARB front winch bumper (no winch), tube rear bumber, roof rack, roll cage, aftermarket lift, dual shocks, 32" BFG a/t's, 42 gallon fuel tank, SS exhaust, Auburn limited slip front, custom louvered hood, hella fog lights, hella H4 headlights, dual Optimas (red and yellow), brand new JVC head unit. Thats all I can think of right now. Truck came from Califonia very little rust. Sat from 96 to 06 in sun, paint is faded. Needs new tie rod ends and knuckle/ axle bearing rebuild ( all parts are included and brand new from Cruiser outfitters/ Marlin). $5,500 FIRM
 
Last edited:
Do you have the mileage of the truck and the engine? 4 speed or 5?

Are the axle's driveable with a suggested rebuild in the future or should they be done rather soon?

Any Pictures of this beauty?
 
There is 139,000 miles on the truck, I was told about 220,000 miles on the motor (not head). I have been driving it with the front end in current condition waiting for spring:) Knuckle is seeping oil, no obvious bearing damage, just figured I would replace them when I put in the new Marlin oil seals. The TRO's do have some play. I can e-mail you some pics if you want, I have no idea how to post them here though.
 
where's it located?
 
pm sent
 
pm sent...
 
pm sent
 
Soory it took so long to answer, I've been out of town. All PM's replied too....I think:)
 
Last edited:
okay, here are some pics for the seller. (don't contact me! lol)

100_5455-1.jpg

100_5456-1.jpg

100_5457.jpg

100_5458.jpg

100_5459.jpg

100_5460.jpg

100_5462.jpg

100_5463.jpg

100_5464.jpg

100_5468.jpg

100_5469-1.jpg

100_5470.jpg

100_5472.jpg

100_5473.jpg

100_5474.jpg


g'luck on the sale Jerry!
 
Last edited:
nice to see you finished the swap, have you put many miles on it? Do all the gauges, lights, etc work? Does it need anything besides the front axle work? Interested...
 

Users who are viewing this thread

Back
Top Bottom