80 series ARB recovery point supports

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Status
Not open for further replies.

Trunk Monkey

Moderator
Joined
Apr 27, 2003
Threads
307
Messages
11,509
Location
Salt Lake City
Friend and I fabbed these up after our own and several other's recovery points on the front of the ARB bar have folded or bent. If you haven't seen one, the ARB tabs crumple pretty easily if hit on a rock, or fold over if you pull on them from the side with a winch.

These are cut for the 80 series bar, they sit right next to the current d-ring tab and weld on. They're laser cut 1/4" plate and will require you to sand off the paint to the side of the tab, weld it on, and repaint - pretty simple.

$20 for a pair, shipped within the US. PM me for payment instructions.

Thanks!

MVC-118S.JPG

MVC-119S.JPG

MVC-121S.JPG
 
Cory,

I like them. But I don't have an ARB. I like the little metal projects you are doing. The spring spacers were one of my best bang for the buck mods.

Eric V.
 
FYI, Rustoleum Black Gloss Enamel matches ARB powdercoat really well. I painted a couple different non-adjacent panels on my old bullbar with it and you couldn't tell the difference. The key is to paint an entire panel, not just a little area. By painting a panel and masking it off where the panel's edges are, the light hides the difference.

Figured this would be helpful info since this mod requires touchup post-welding.
 
Thanks Cory,

I just got mine in the mail and they are very high quality.

I am exceited to get them welded on.
 
Status
Not open for further replies.

Users who are viewing this thread

Back
Top Bottom