3M lense protectors on... (1 Viewer)
- Thread starter sjcruiser
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Yep, I did this last week and let Doug know it went pretty well. Only tough part were the corner markers. Just as the instructions said they had to be stretched a little to form properly.
There was even a little bit of scrap left to cover the front lights on my ARB bumper. Since those have some raised lettering, there are a few spots where the film doesn't lay flat. But he said to use a hair dryer to heat and form to it better. I haven't tried that yet, but they are still staying on even after about a week of rain.
Thanks,
Gary
There was even a little bit of scrap left to cover the front lights on my ARB bumper. Since those have some raised lettering, there are a few spots where the film doesn't lay flat. But he said to use a hair dryer to heat and form to it better. I haven't tried that yet, but they are still staying on even after about a week of rain.
Thanks,
Gary
