Hello everyone,
I’m here to the forum and also to the land cruisers world. I recently purchased a 70 series 1990 Land Cruiser prado with the 2LT-E engine an automatic transmission, I changed the engine head as you probably know they crack often, mine was also cracked. After putting everything back in place I’m not able to rev past 1800 rpm, therefore the transmission doesn’t shift past 1st gear, I unplugged the crankshaft sensor wires (white and red) and plug them back, but not sure if I plugged them in the right position. Could anyone post a picture of those wires please? Or tell me if the white goes left or right? Thank you for you support.
I’m here to the forum and also to the land cruisers world. I recently purchased a 70 series 1990 Land Cruiser prado with the 2LT-E engine an automatic transmission, I changed the engine head as you probably know they crack often, mine was also cracked. After putting everything back in place I’m not able to rev past 1800 rpm, therefore the transmission doesn’t shift past 1st gear, I unplugged the crankshaft sensor wires (white and red) and plug them back, but not sure if I plugged them in the right position. Could anyone post a picture of those wires please? Or tell me if the white goes left or right? Thank you for you support.