2004 105 LandCruiser standard manual - 4WD issue (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 31, 2023
Threads
1
Messages
0
Location
Australia
I have a 2004 manual 105 series Land Cruiser Standard with part time 4WD (from factory). I recently replaced the clutch and since then when I put the car in 4WD, no lights come up on the cluster like they previously used to - to indicate that the vehicle is in 4WD - the car still mechanically goes into 4WD it just no longer shows me on the dash. I can't remember exactly what light it used to use to show it was in 4WD but I can see the cluster has three lights one for each front, centre and rear diff lock which my car doesn't have any of however I'm assuming it used one of these lights to show it was in 4WD? If anyone can help verify this for me it would be much appreciated.


The wiring to the 4WD indicator switch has no power at the plug which I'm assuming is the issue and need to start tracking back from there, trouble is I can't find any wiring diagrams for my specific vehicle, all I can find are for ones with full time 4WD.
 

Users who are viewing this thread

Back
Top Bottom