Hi All -
Trying to get my 1998 Tacoma 4x4 transmission/transfer case back in after changing the clutch plate and pressure plate. This thing is a bear - already spent 3 hrs trying to get it back in. I have a transmission jack and alignment dowels (cut off bolts) in two of the lower mounting holes, but it will not line up and slide in. Anyone have any other tricks/ suggestions? It came out tough. I guess going back in will be the same way.
Thanks
Trying to get my 1998 Tacoma 4x4 transmission/transfer case back in after changing the clutch plate and pressure plate. This thing is a bear - already spent 3 hrs trying to get it back in. I have a transmission jack and alignment dowels (cut off bolts) in two of the lower mounting holes, but it will not line up and slide in. Anyone have any other tricks/ suggestions? It came out tough. I guess going back in will be the same way.
Thanks