1987 4Runner - $2k OBO
Chicago area (NW suburbs, Cary IL)
1987 Toyota 4Runner - $2k OBO
35” Krawlers, Lockright in front diff (IFS), electric locker in rear, Marlin Crawler 4.7:1 xfer case (76:1 crawl ratio), twin-stick shifter, heavy (high torque) flywheel, on-board air, front and rear custom 2” receivers and 50A cabling, 1” body lift and fender mods to fit tires, low-profile xfer case crossmember, 22RE (2.4L EFI) engine with metal chain guides, LC Engineering header, new exhaust, new clutch, 2” taller Skyjacker leaf springs, manual locking hubs, brakes are new/good (including e-brake).
Truck runs fine (I sometimes drive it to work on 31” tires, 30 miles round trip).
Issues: leaking front axle seal, rear window rolls down with jumper wire, steering bushings need replacing, shocks are weak, clutch slave cylinder boot is torn (I have replacement), manual hubs need cleaning.
Looking to sell before October.
Kenton
847-462-8042
Chicago area (NW suburbs, Cary IL)

1987 Toyota 4Runner - $2k OBO
35” Krawlers, Lockright in front diff (IFS), electric locker in rear, Marlin Crawler 4.7:1 xfer case (76:1 crawl ratio), twin-stick shifter, heavy (high torque) flywheel, on-board air, front and rear custom 2” receivers and 50A cabling, 1” body lift and fender mods to fit tires, low-profile xfer case crossmember, 22RE (2.4L EFI) engine with metal chain guides, LC Engineering header, new exhaust, new clutch, 2” taller Skyjacker leaf springs, manual locking hubs, brakes are new/good (including e-brake).
Truck runs fine (I sometimes drive it to work on 31” tires, 30 miles round trip).
Issues: leaking front axle seal, rear window rolls down with jumper wire, steering bushings need replacing, shocks are weak, clutch slave cylinder boot is torn (I have replacement), manual hubs need cleaning.
Looking to sell before October.
Kenton
847-462-8042
Last edited: