switchpro

I just installed a Switch-Pros unit to control my ARB compressor, and front and rear lockers. The standard wiring uses three switches: one for the compressor; and one for each of the lockers. This seemed like a waste of one switch since the compressor must always be on when one of the lockers is...

I am trying to install a Switch-Pros 9100 but am running into a problem connecting it to my ARB twin compressor. The ARB plug is on the left and the Switch-Pro harness connector in on the right in the image below. As can be seen, the two will not mate: the ARB contacts are higher than are the...

There are numerous recommendations for where to mount the Switch-Pro control head, but I decided that having it on the back of the visor would be best. It would be readily accessible yet easy to store. I 3d-printed a simple bracket that holds it firmly. The only problem is that the visor cannot...

I've curious to see what ppl have set up in terms of aftermarket battery terminal setups, Switchpro or Auxbeam setups, all of that. I bought a Switchpro on discount, and the OWL Expeditions Accessory Tray: 100 Series Land Cruiser and LX470 Accessory Tray -...