switch

1995 LC Tested the antenna switch on the dash as per the FSM: All conditions tested continuity correctly except for the illumination circuit. Question is since there is no continuity for the illumination circuit, does that mean the switch is bad and possibly won't operate the antenna or...

OEM Winch Remote Controller with the original bag. The remote is in excellent working condition; the bag is has no tears but shows some black scuff marks on the inside. This winch controller works for all Toyota Aisin winches installed on vehicles listed below. Part 38640-35010 (SWITCH ASSY...

And if so, with what? I have at least 9 blank spaces on my dashboard. I know there was the locker switch, a subtank switch, ECT, security system and maybe a diesel idle-up switch, but what else? I am more interested in factory stuff than what can be retrofitted like the power inverter or...

I am needing a cold start timer switch for an '88 3FE. It's the square connector and the no longer available part number is 89462-20010. Below is a pic of the harness side of the connector.

Vacuum switch (part# 17650-61010) out of 03/76 FJ40. $30 plus shipping. Located at 57703 Thanks

Located in Modesto, CA Local pick up only. -99 e-locker axle, it's missing the brakes but is complete. -99 e-locked third member which has been removed for above axle. -Slee, e-locker control box: Slee - Electrical Switches -Factory e-locker dial for Rear and Front Locker -Extra passenger side...

Cleaning up the office and found this jewel. Not much else to say. You can run the numbers to check production, but my sense is that it fits 67-72) Price? Any fair offer with a qualifying order. No PMs please. Mark

Hello everyone, I have the Ford Contour fans mounted and wired up to a relay (so I have the power wire, ground, and acc. wire coming out of the relay). My problem is finding the best way to switch the fans on. The kit I bought came with a probe, but I have a brand new Champion all aluminum...

Is there a ball that mounts behind the reverse light switch, in the transmission, on a 1978 fj40?

Hey guys, i'm looking for a CDL switch for a '93 FZJ80. If ya have one lurking around, or know where one is feel free to PM me. Thanks in advance!

I recently noticed that the stock rear e locker switch on my 99 and the mirror controls do not light up(. Are the bulbs out or did they never light up? is there a bulb I can replace?

Looking for one of these manual GLOW dash switches from early diesel land cruisers. Let me know if you have one for sale or know where I could find one. Thanks!

Fellow Mudders, I am in need of a wiper park switch cover for a 1972 FJ40 wiper motor. This is the snap on one not the one that screws down. I understand that they aren't just laying around all over the place, so I want to make my own. I will be casting this from urethane, so I can make as many...

I have a bad power seat switch. What's the most efficient way to replace the power seat switch? I found some instructions for replacing foam cushions but I was hoping it wasn't as involved.

So here's the story. I have a HEI distributor in my rig and running a Weber carb (that's going away at a later time). I have all new aftermarket wiring with literally one pink wire connected to the "battery" spot on the HEI. I want to go back in time and install a Toyota distributor with...

Trying to get out town on a wheeling trip and having problems locking the center diff. Dash light blinks on and off and not holding steady lit to show center diff locked, preventing locking front/rear. So, I removed the CDL indicator switch from the Trans Case. Not depressed it is an open...

I'm looking for a NSS and complete harness for a 97LX. Like the picture below but harness needs to be complete, not cut.

I'm looking for a CDL switch Let me know if you have one. Thanks in advance.

I'm getting ready to install an FJ60 carb cooling fan in my '76 FJ40. I was going to keep it simple and operate it manually using a switch on the dash. I'm thinking it would look better to use an OEM or OEM style pull switch instead of a toggle switch. Any ideas?

Im after a new dome light switch for my 42 its a 24v. I just need the striker part thats in the door jam. Mine had rusted up or the spring inside is broken.