solenoid

So installing my winch onto the new bumper and for some reason the solenoid clicks either for a sec or 10 second( if I hold down the out button on The controller) however nothing happens with the line moving. I checked the voltage on the cables and we are around 12.5 volts when the “in”is...

Looking for some inspiration for where to mount my winch solenoid in the engine bay and the wire routing. This is for a CBI Front bumper and requires the solenoid to be mounted separately and I would rather not have it in front of the radiator (where it was originally on the truck I got the...

Hello, I lost the mounting screws for the solenoid on my Warn EVO 10k winch and was hoping someone could let me know what size bolt I need to find as a replacement. It’s item 7 in the diagram below. https://www.warn.com/Attachment/DownloadFile?downloadId=2505 Thanks!

So when I go to start Lexi, especially when it's cold, I might get a short grinding noise, and the starter will just spin. I let off the starter of course and usually the second (or third time yesterday) it will engage and start. Is it serviceable?

I currently have a 74 FJ40 with a 2f engine and 75 carb. Can I use the original setup on the 74 which consists of the wire on the harness side coming through the firewall (attached picture) or do I have to use the 1975 setup? Any help would be greatly appreciated. Thanks

Sorry if this has been asked before, my search didn’t yield any info. Does anyone know where to find a gasket for a pre-‘75 idle solenoid? Do I need to make my own? Also, I haven’t seen much on these earlier solenoids. Are replacements NLA or does someone sell them? Thanks!

I have a 2020 hammerhead 250. New battery and solenoid. When I flip the start switch the dash lights up but the engine does nothing I don’t hear the solenoid click but I tested it on the bench. Could a locked up starter cause this? Any help would be greatly appreciated

Looking for suggestions on replacement/upgrade

Having trouble with idle solenoid in my stock Aisan carb. Just finished the rebuild kit and was having trouble with idle and figured it was the solenoid. It bench tested fine, but doesn't work once installed on the carb. It has 12v going to it, and I ran a ground straight to the battery and...

new but blemished packaging, still in plastic bags inside the boxes, made in Japan (which are harder to come by versus Chinese widely available) 1 x - Timing 2 x - 1st and 2nd Shift 1 x - TCC Solenoid $200 shipped to your door

Hello mudders, I am working on developing a trans control harness and tune for my 1993 USDM 80 series so I can use a Haltech standalone ECU. I have been able to successfully map A34x series transmissions in Tacomas and for the most part the A442 (AW450-43LE) looks to function the same really...

Guys, we've finally got the place where I need to replace the OEM Master Cylinder and ABS module on our 2003 100s. We are right at 280K miles and the solenoid will not pass the startup checks. I have the ABS light, Brake light and VSC light illuminated. I read a few threads on here and it does...

Just curious as to why my sub tank fuel solenoid is set up like this. It has two one isn't connected to any lines but is wired up. The second one has lines feeding into it and is also wired up. Not only that but on of the lines coming from the main tank is pinched closed. Wtf was going through...

The solenoid on my 77 series pzj finally pooped itself and so searching around for a replacement it appears that the OEM one has been discontinued (85440-60160). Is there a decent aftermarket option for this part and/or what other solenoids can I run from other vehicles as a replacement?

Hi all, Just hoping for some input before potentially blowing a lot of $. Late '95 fzj80 with a A442f. I was driving along at 100kmh when my box Down shifter back to 3rd for no reason. Since then this has developed into not dropping back to 1st at traffic lights and has become so bad that if...

Done enough research and believe I have isolated my problem to the fuel cut off solenoid….do these work sporadically before failing? My 2F engine runs fine for days….then occasionally will give me all signs of a malfunction fuel cut off solenoid (will not idle, cuts-out while driving, and will...

I am going to do the solenoids on my 94 as I’m starting to experience some poor shift behavior. I know there are the 4 shift solenoids but no one seems to mention the pressure control solenoid. Is I needed as well or only the shift solenoids? Can it be replaced just as easily?

1980 FJ40 with a weber 38 carb looking for a switched / acc 12v source - So far, I've read that some people here like to use the ignition coil - however mine only puts out about 6.5-7v, so I assume if I used that, that's gonna take longer for the carb to open up. I've been doing okay without it...

The past few times I've driven my 60, I'll park, turn it off, and try to start a few minutes later. Turn the key and all I hear is the solenoid click. Nothing happens. I go back and forth of knocking on the starter with something and trying to crank it. Eventually, it starts. I'm not sure if me...

Yesterday I was having some issues starting my 60. Disconnected the terminals and cleaned up all the connections I could. While doing so the double eyelet for the fusible link feel apart from corrosion. While messing around with that I noticed that the large black wire (small black FL wire)...