solenoid

Hello everyone, Does anyone know what the Aisin part numbers are for the 3 solenoids in the A343F? My transmission is severely slipping/chattering in reverse under load and I'd like to swap out the solenoid responsible for the reverse circuit to see if that fixes the problem. I've checked the...

Hello All, I've long wanted an FZJ80 and finally pulled the trigger on one earlier this week. The rig I bought is a 1993 with a tick over 200k. I think it's an A442F transmission. I had the prior owner meet me at a friends mechanic's shop who primarily...

I just removed the starter from my BJ70 (Ugghhh) after troubleshooting a clicking noise. Both solenoid contacts were replaced, the battery side contact which was totally eroded just happens to be used on Dodge Cummins trucks, so easily obtained. Once installed the starter turned over the engine...

I've seen quite a few threads about starter problems similar to what is going on with my '76, but not quite. When I turn the key to "start" it cranks fine and sounds like it's running but as soon as I release the key to the "on" position the engine dies. Same thing happens with the ignition...

Hi ya'll! I've searched for more than an hour :confused: because I KNOW this info is somewhere.. but can you tell me where to buy transmission solenoids for the A442f? I need a S2 and ST solenoids. Are all of the solenoids the same PN? Also if you know what the ST solenoid does, I would love...

I feel silly asking, but I have a rare bird here. It's a 1989 JDM HJ61 (rhd) with a five speed and 12-ht diesel. It has a 4wd button at my left knee and the light engages as well as a lever 2H-N-4LO on the floor. Up front it has Asisn locking hubs. First thing first; I thought it was a...

Hey all, I'm new to the forum as I've just purchased my first land cruiser. Bought a 1991 80 series with just around 75,000 miles. As it's a used car I'm on heightened alert about ever creak and rattle I come across, but I'm pretty sure this one might be indicative of something worse to come...

I have an unfamiliarly new Starter Motor that looks a bit different than the old one and unfortunately does not have any labels on it that I can see. So my question is simply, Where does the IGN START wire connect to my specific starter solenoid? This wire.... Where does it connect to this...