solenoid

The past few times I've driven my 60, I'll park, turn it off, and try to start a few minutes later. Turn the key and all I hear is the solenoid click. Nothing happens. I go back and forth of knocking on the starter with something and trying to crank it. Eventually, it starts. I'm not sure if me...

Yesterday I was having some issues starting my 60. Disconnected the terminals and cleaned up all the connections I could. While doing so the double eyelet for the fusible link feel apart from corrosion. While messing around with that I noticed that the large black wire (small black FL wire)...

Replacing original solenoid but unsure of function check. The new plunger doesn't visibly move when solenoid energized 12V. It clicks with a thump that feels like internal movement. The end of the plunger has very small pinholes, and an O-ring at the end. Is there an internal function that...

Well, looks like my number is up. Over the weekend I started having transmission trouble. My truck is a 1994 FZJ80 with the A442F transmission. Unfortunately, the O/D light is out so I can't get codes from it. Checked engine codes and there aren't any. Anyway, when I put it in D I get no power...

Just pulled the trans pan off my 80, replaced the fluid strainer and flushed the old fluid out through the cooler mounted near the radiator. Put the pan back on with oem silicone and used Valvoline ATF max life for the fresh fill up. BUT one thing I did not do was replace the shift solenoids...

I recently picked up a used Champion Power Sports 18051 recovery winch, but found once the cover was removed that all of the wiring is disconnected and some possibly missing for the two solenoids that control the winch. Would anyone happen to have a wiring diagram that may help me to rewire this...

I replaced my starter on my 09 LC as a precaution and now getting the old starter rebuilt at a local alternator/starter repair shop. I ordered a new solenoid when I ordered the new OEM starter from Toyota and took them to the repair shop. I just got a call from the shop saying he could not...

Looking for SOLENOID ASSY, DOOR CONTROL BACK TOYOTA PART NO.: 85450-90A06. This is the auto lock unit for the rear hatch door. Mine is not working. The part is discontinued. I'm looking for a functioning replacement for my 1988 FJ62.

My 1975 FJ45 (early 2F engine) stopped idling recently. Eventually I discovered that if I hard-wired the fuel cutoff solenoid on the carburettor, the engine idled perfectly. The solenoid is OK, it seems. When I plug it in to its regular part of the wiring system, there's little or no power...

I did a quick search and found a few relate post but nothing exact as my problem. Went to pull the Land Cruiser out of the garage today and noticed that the started stayed engaged. This has happened before and I usually shut it off and restart no problem. Well today it kept trying to start after...

Just wondering if anyone has experienced and solved this issue. This morning I tried to start my son's 94 and I turned the key several times and no click but the instrument panel lit up with each swing of the key. I tried with the shifter in Neutral and still no crank. I then held the key in...

Can someone tell me what's going on here? I'd been having trouble with my winch/remote operating, and on further inspection noticed one of the pins on the solenoid box is deeper than the rest. See the pic below - the 'female' pin on the bottom of the picture is sunken deeper than the others...

hey guys trying to find where my no power issue is at , I have checked the fuse bank and all good , I've tried doing a conutinty test but the fuse bank is giving me a ok , but still no power at plug , I tried a jumper from battery to fuel solenoid and it did click , I've looked over the wiring...

$125 shipped! Long Discontinued by Toyota, a New Idle Control Solenoid (ICS) to fit late FJ40s or FJ60s. OEM (Aisan) Two-wire. This will work on either the one-wire or two wire set up. If one wire, you need to ground the neg wire to the carb body. Green Connector is not for a USA Land...

hi im trying to convert my 24 volt sytem on my hdj81 and make it 12 volt because ive been dong research and there is alot more 12 volt staters and there cheaper and last longer (we bough a starter and it broke after 6 months) thats why i want to convert. some guy suggested it to me to convert...

Trying to trouble shoot this P0773 issue in my 80 since rebuit my engine couple yrs ago. Replaced solenoid #3 (#35250-50030) and confirmed that it's dead. Pull battery to clear everything , no code in ODBII. Go for a drive until trans is hot, ODBII read P0773 but no CEL. Some time CEL pop...

My shop has narrowed down the shifting issue to a bad solinoid. Can some one tell me which one this is. I have a pict of the one he says needs to be replaced but can't figure out how to upload the image. I can email you guys the pict if someone can send me their email address. Or a link...

Just finished a desmog on my 87 - 60 series and truck is running better than ever. Still has a small idle problem. It idles better now than it did. No intake leaks. I removed the Fuel Cut solenoid to inspect it and it is working but found that the o-ring is missing. Do I need the o-ring on...

In need of some help... so the PO of my truck jerry rigged the throttle valve solenoid on the carb. I'm installing a trollhole carb and need to get this straightened out so I can install the carb and do a valve adjustment. They spliced the solenoid directly into the harness, so I don't have a...

Well it's not much of a rebuild, but I took apart my malfuntioning I.S. and got it working. Perhaps this has been documented. Drill out the 3 dimples holding the cover on. To remove the cover I clamped one of the mounting ears in a vise. I then used channel lock waterpump pliers to wiggle...