pressure

I'm rebuilding my 1989 steering box (BJ60 but basically a RHD version of the FJ62 box). I have all the seals/O rings/teflon rings etc except the pressure port seats. Looking globally, (things might be different in the US), three different parts were used for the seats: Early 60 Series (80-83)...

Hello. First time larger-than-hatchback owner of a '96 GXL and confused about tyre pressure recs on inside door jam panel. There are two stickers with differing pressure recommendations. Is this normal, is one for 'roads' and another for off-road? To complicate things the previous owner used...

I would like to replace the aftermarket guage that came with my truck. It has wires to the light but what looks like a tube to the guage. What I am looking for, for a replacement is it just a mechanical guage if I don’t want a light?

On a recent drive my oil pressure gauge went from the typical 1/4 reading to 0, jumped back up once or twice and now reads absolute 0, no reading or movement. Pulled over immediately, checked oil level, started back up, no odd sounds seems to be running normal. I've never heard an engine run...

I'm considering adding an adjustable pressure switch to the onboard air compressor. The goal is to have an adjustable air pressure switch so that I could change the cut-off pressure to suite the tires. Let's say it cuts the fronts at 35 and the rear at 40 or 45. This means I can be free to do...

I am going to do the solenoids on my 94 as I’m starting to experience some poor shift behavior. I know there are the 4 shift solenoids but no one seems to mention the pressure control solenoid. Is I needed as well or only the shift solenoids? Can it be replaced just as easily?

I bought this cruiser with a Turbo kit installed, and the AC lines never installed or rerouted. So I just finished hooking up the new hoses, installed a new drier, and added some oil to the suction side of the compressor. When I tried to run the compressor, the clutch was not kicking on when...

Yesterday we took the Landcruiser out for about a 150 mile round trip through some elevations. When we got home and off the highway at a light the oil pressure as read by the gauge dropped to a seriously low level and the car started vibrating a bit at idle. By seriously low I mean there was...

Just got an FJ60 and clutch no longer gives pressure when pressed down. Went down to check out the clutch fluid and the master cylinder was empty. I then followed the line to the slave cylinder (release) and it showed signs of leaking. Attached are photos of the slave cylinder. I tried to bleed...

What have people done about this, if anything? The factory oil pressure gauge is ok but it tells you basically nothing other than 'yes there is some oil pressure' or 'no there is not'. My 80's 1hz is now less than 300 km off 700 k km's and is the original motor, never removed, never pulled...

So I've been going through our "new to us" 1994 LC and replacing/repairing anything mechanical. Today was diagnose and repair the inoperable oil pressure gauge. I found that the sun harness has rotted off the oil pressure sender. Toyota part number 82221-60010-B is no longer available. Is this...

I have a 2015 200 series with 98k. I posted another thread over the weekend on a timing chain tensioner noise. Thanks to the great folks on this forum for weighing in. I’m now looking to go to 5w-20, which is what the owners manual says you can go to if 0w-20 isn’t available. Is it better to...

What would be the result If I take the singal wire from the 2000 Tahoe 5.3 using it's oil pressure sending unit that I swapped into my 88 FJ62 and send that signal directly to the FJ62 oil pressure gauge?

2002 100 series, 282k miles. Oil pressure is stuck on high. I changed the oil pressure sensor, the one down at the oil filter, and no change. Anyone else ever seen this. Everything I see is about low oil pressure and the above always fixes it…. Thanks in advance guys.

I was expecting to use some sort of glue to attach this, but it has double-sided tape already applied. How long do you apply pressure for before it is safe to drive without it falling off?

Hi All, Could I get a sanity check on normal behavior of the fuel pump relay (FPR). I'm trying to determine if I should be observing cycling of the FPR back and forth during engine warmup. By observing, I mean hear it clicking and feel the relay cycle periodically by putting my hand on it...

Hi, I replaced an old hose - see picture (Differential Pressure Control PN 95337-06020), with standard fuel hose (NBR/PVC SAE30R7). Should I be worried about it? Does this hose require higher standards? Thank you!

Hey I just bought a 2lt manifold for my early style engine. Obviously I don't need it but I just had a thought. What if I used it as an emergency shutoff in the case of a runaway condition? I could hook it up to a choke style knob in the dash and pull it if I need to use it. Could even use it...

Just curious to compare. With engine off, my oil pressure needle sits far below the lowest tick mark. Is this normal? Where does yours sit? I was thinking that it should sit exactly at the lowest tick mark.

Gentlemen, I just picked up a 2011 LX570 that has a couple of problems: C1715 Front Acceleration Sensor Right Malfunction P0552 Power Steering Pressure Sensor I have no experience with either of these parts but apparently they both need replaced. I have ordered the parts, now to work out how...