help

  1. effjay80

    Lines above transmission help?

    Replacing speed sensors and AT temp sensor and solidifying frayed wiring and connectors around transmission on my 94. Can anyone help me out with what the soft lines with the T are above the transmission right behind speed sensor 2? I can't figure out where they come from or where they go when...
  2. stusic

    HDJ81 Won't Start Without Help and Don't Know Where to Go From Here

    Good Morning Folks! I'm having a starting issue that's driving me crazy, and maybe you fine folks with your big brains can help. I cannot start my truck (RHD, 1HD-T) with the key. I can sometimes (50% of the time) start it by connecting a jumper wire from the LH battery (+) to the starter (via...
  3. BTLSHP

    Help with a bit of interior work...1994 Series 80

    We have what I think is a well cared for 1994 Series 80. It has 225k miles of which 98% are highway and 2% were tough gravel roads in West Virginia. Chains, not rock crawling. It gets a thorough detailing 2x yearly. The owner my father replaced the front seat bottom 10 years ago with a vinyl...
  4. NookShneer

    Real Time Help: ICS needed along I-70 / I-15 Utah

    Having issues with starting and keeping the truck running. Have diagnosed that the ICS is failing and wondered if anyone along the route home from Solid Axle Summit might have a spare I can buy from them. Headed out today and will be traveling W on I-70 to S on I-15 stopping in the Zion Area...
  5. J

    69 fJ40-switch terminals

    Please help me identify these switch terminals.
  6. H

    HELP: searching for reason audio gets no power

    Gotta love a 20 year old rig! Yesterday, I brought my rig home from my independent mechanic who had just repaired my failing ABS system. He also replaced the Hi-Lo shifter that I'd removed to unfreeze. Two my surprise, I found that my audio system was not getting power. All non-audio buttons...
  7. G

    Dobinsons lift - HELP

    Need some help figuring out what to do next. FJ40 with 11/78 build date. Installing a Dobinsons full IMS kit. Passenger rear went together great. Driver side rear is presenting a challenge. The spring hanger pin flange screw holes do not line up with hanger bracket. I tried the 3...
  8. Tennessee Jed

    Help me pick a daily driver

    I'm about to pull the plug on a Troopy and so will be getting rid of my FJ Cruiser. I would like to get a good solid toyota car for a daily driver. Naturally I'm going to bring my obsessed attitude to this just like I would a cruiser. I'm seeing several 90s Camrys for what seem to me to be...
  9. T

    Help Diagnose My A/C

    My a/c blows ice cold when I first start it up in the morning after it's sat in the garage overnight. It will blow cold for the duration of that drive. However, once it sits in the parking lot somewhere and the sun heats up the truck (Tucson, AZ), it doesn't blow cold at all. The air will...
  10. 14bt71

    Bj70 anti inversion help!

    Hey guys arfter some opinions on my shackle angle and the pin location. Ive just installed ironman +2 springs and standard length a.i shackles in and the pins are touching the hanger mount with the truck off the ground. Then sitting there is around 15mm on driver side between pin and hanger...
  11. cvenom96

    Help with part numbers or if available

    When I was replacing my condenser the other day, I remembered I never replaced the upper mounting bracket/bolt on the passenger side. It wasn't there when I replaced the condenser previously and just forgot. It looks like the mount is 88688-60190 but that shows discontinued. Any info on if it's...
  12. hdjtachtig

    Help identifying this part, OEM or AM?

    Someone offered me this compete ignition as being OEM. I have doubts because I don’t see a single mark on it. Is this OEM or aftermarket and which engines would it fit?
  13. MistyGoat

    Help Identifying a Mystery Mod?

    I've been staring at a mod that a PO did on my BJ74 for a while now, and now felt like a good time to get to the bottom of it. I have a feeling @Malahki, PO that did a serious amount of work and upgrades must have installed it, but I don't think he's still active on MUD, but if he sees this...
  14. Mia070

    With the LC100 on vacation.. Help!

    Hi guys, I went on a trip from Holland to Croatia, with a small detour to France. My cruiser is fully loaded with a rooftop tent, drawers, battery and luggage. The truck has stock suspension and AHC and was doing just fine until the first stop in France.. The 'low' button for the AHC never...
  15. aam2gxor

    My GX suddenly has this scary issue, HELP.

    It won't start smoothly, something seem to be jammed/not initiating. I just changed the fuel pump (a recall) and the battery, so they are not the issue, it existed before these changes even. Please check the video link:
  16. D

    1hdt alternator help

    So for the longest time I've had issues with the dash lights blinking while driving I suspect it's the alt and not the plug simply based on mileage I'd read that a tercel alternator fits. But when I bought one, mines different. Mine was slightly larger and had an oval plug. From reading...
  17. Lowkey51

    Potential new 100 but Rust issue? Need help

    Any concern with rust based on these pics? Is a little too much?
  18. Joe45

    Tailgate Reshape Help

    Good morning everyone. Yesterday I was backing up my HJ45 in the yard, got distracted, and hit a tree! Did a good number to the tailgate. Any ideas/suggestions on fixing it? The body below the tailgate I can fix with a heavy hammer, but the tailgate worries me. You can see the panels...
  19. newmexicokid

    Help identifying sliding windows

    I picked these up on KSL Classifieds. They were advertised as FJ40 sliding windows. When I got there he told me they came out of a South American Landcruiser? I’m not familiar with any of the now discontinued sliding side windows so I figured I would roll the dice. Can anyone help me identify...
  20. foxfab

    SAS help - steering shaft

    Hey all, can someone post up pics of what you did for your SAS steering shaft? What parts did you use? I have both an 80 shaft and the 100 shaft. I don't want to reinvent the wheel and start cutting things that I dont need to. Thanks!
Back
Top Bottom