I am in search of the part number of an ECU for a FZJ80 that meets the following criteria:
1. Controls the 1FZFE engine.
2. Controls the A442F transmission.
3. Controls the ERG.
4. Has provision to accept O2 Sensor inputs.
5. Does not have provision to accept Crankshaft Position Sensor input...
I have a '96 FZJ80 with front/rear a/c and a fridge console.
A few months back, my alternator went bad and voltage dropped and caused the a/c to slip. The slipping in turn caused the temp to elevate and eventually blew the seal of the clutch bearing and binded it. I believe this is what...
My windscreen seal is leaking at one corner. This is a seal which I had a windshield shop installed about a year ago replacing a former seal which was also leaking badly. I was not aware of the sealant around b/w the windshield and the gasket at the time (neither was the windshield shop) and I...
I have a '96 FJ80 and replaced the switch panel on the driver's side some 2 months back. I seldom need to adjust the back rest as mostly it is only me who drives, but every once in a while I still need to do some minor adjustments.
My problem is every now and then, the seatbacks on both side...
In the process of putting back my overauled rear differential, I inadventently tried and found that the rear output flange of my transfer case was having a unusually large axial play.
When I had the truck jacked up, I could clearly hear that the transfer box was giving noticeable revolving...
A friend of mine is fighting the reverse issue of his A343F. He read from the Mud that there are some with specific serial numbers that are known to require these fixes, according to some Toyota TSBs.
He looked under his rig but have not been able to find the silver plate with the serial...
I have been trying to narrow down a vibration/rotation type of noises that become appraent when my '96 FZJ80 is driven at a speed higher than, say 30Km/hr, the higher the speed, the louder the noise.
I tried rebuilding the front and rear axles (replaced worn spindles, axle shafts, birfields...
I have a '96 FZJ80 with lockers and a VC in my transfer case.
Last week, when I finshed rebuilding my front and rear axles, I inadvertently refilled the front nd rear diff, and the transfer case with the Toyota Limited Slip Differential GL-5 gear oil. A couple of days later, I started to...
I am in the process of rebuilding my front axle. Removed the birfields with their shafts on both sides.
When I tried to hand rotate the shafts while holding the birfield shafts, I could feel and see that there are play from the worn splines from the CV stars and the axle shaft. The stars do...
Mine is a '96 FZJ80. I replaced my power seat switch assembly of the DS with a barnd new part in an effort to fix the following problems I had:
1. Seat cushion front would not go down after it had been moved up.
2. Intermittently the incline/recline of the seat back did not work. Sometimes it...
I am contemplating upgrading to a reinformced version of Shafts/Birfileds and 4.88 front and rear diffrerentials.
I would like to ask you to recmmend brand/models of the above mentioned setups based on the following criteria:
1. Made in the USA
2. Chromoly preferred (and I assume that this...
Heard that these are very bright and reliable.
Just wonder if anyone has tried them on the FJ80. If yes, please share your view as to these lamps.
It would also be very great to see some pictures of those rigs with these lamps installed.
SRS Warning Light is On...Code 31
My SRS lights came on this morning, after the truck had not been driven for a couple days.
I checked the SRS Error Code and it threw a code 31 I believe.
I tried but could not clear the code using the code scanner.
Anyone has similar problem please advise as...
My '96 FZJ80 started to run rough last week. When I tried to accelerate, the engine would rev to about 2000 rpm and dropped back at times, before I could get the engine speed to go beyond 2200 rpm. In addition, sometimes when I got it to reach 2500 rpm, it would drop back again. This is...
I am in the middle of servicing my front differential (lock version). I removed the differential from its case and found that there is no adjusting nut for setting the side bearing preload, as mentioned in the FSM.
These are the pix I took on the differential I removed.
Anyone care to share...
I have been having this 1st gear slipping when I take off from being stationery. Also, when the truck was in low speed (like 5-10 km/hr), stepping on the pedal to try to pick up speed would likely result in apparent slipping. This slipping was also obvious when I tried to pick up speed (from low...
The day after I finished upgrading my stereo, the FUEL TANK (orange color) warning light came up in my dash. Fuel was low in the main tank and when I tried to press the sub-tank transfer button in an attempt to pump the fuel from the sub-tank to the main tank, the green light on the button...
I converted my regular H4 headlights to a set of Philips H4 HID a few weeks back and has been really happy about the performance of the HIDs.
However, I realized a couple of days ago that my Hi-beam (the blue lamp) in the dash did not come on when I flickered to Hi-beam. I thought the bulb in...
At the time I was putting back my front driver's seat back to the rig earlier today, I realized that the power seat only slide on one side when the button was pressed. I took it back out and found that the worm gear has been close to completely wiped out. Then I checked the part number and it...