Water from rain and snowmelt leeches metal from the waste rock of the mine and then collects in the quarry, but Hamilton noted that the water is not highly dangerous.
Stolen from here: http://thedartmouth.com/2007/07/27/news/coppermines
Could be licensed as and show vehicle - there is a law that would allow minimal miles for a show vehicle.
Other than that call an insurance company with the VIN and see if they can even insure such a beast - may not be able to if the vin is completly different. if they can insure it then...
79$ is not a bad price at all.
Was not looking for a backwoods engineering solution so much as to see if anyone had fabricated a replacement with something like what the turbo ricers use to do intercooler piping. 3" mandrel bent aluminium/stainless with silicone couplers.
I looked into doing...
Was up on the rim a couple weeks back and the morning start showed rough idle and running. A quick check over the engine compartment revealed that the intake boot has cracked almost all the way around about two inches from the intake end. I fixed it temporarily with some aluminium tape but will...
Admittedly this is neither a Land Cruiser or on craigslist but its local and I think its interesting.
1969 Nissan Patrol in Phoenix
Nissan : Other Pickups Nissan : Other Pickups | eBay
If you dont want to spring for a scan guage and you have an android phone you can get a bluetooth elm327 module from amazon (15$) and use the torque application on your phone to look at and clear the odbII codes.
My 95 is 6/95 and is ODBII, the best way to tell if the plug is located in the...
Pretty sure thier is a cable back there that could be replaced/lubricated. IIRC it looks alot like a bicycle break cable but may be thicker like a motorcycle clutch cable.
Well sounds like it could be about anything. How many miles does the rig have, what modifications have you made if any? What were the conditions when it failed and prior to failure (throttle pos, temp, oil pressure). Do you know if its been misfiring? Check engine light? Do you have a scanguage...
The thirds/axles should swap but you will need the diff ecu and harness as well.
It may be more prudent to list what you would like to swap but most of it will move over - the newer truck will have more electronics for odbII so that may be a bit different but the rest should be very similar or...
Havent seen or tried this stuff but its much cheaper and removable. No idea how it would hold up...
DYC Home - Plasti Dip For Your Car - Resources & More at DipYourCar.com NEW Glossifier
Yes but there isnt much room above them, so if you raise the body up a bit then you can build/buy extended mounts. This gets you some extra tire clearance while saving you from having to lower your bumps. This is assuming that the tires will actually still fit in the wheel well...
Also check on the evaporator behind the glove box see if its getting cold.
could be the controls are wonky.
Agree with masses though, sounds compressor ish - check the procedure to jumper it.
I just wanted to mention that all cruisers have that left lean. The axles are not centered, the gas tank isnt centered, the weight just isnt centered. Its just the nature of a cruiser to lean left.
When installing an lift you should notice that one of the springs is for the Right and one for...
AFAIK IOS(apple) requires a bluetooth encryption chip and a licensing fee in order for anything to work/be compatable with is junk. This not only requires design changes but hardware and licensing fees that generate them more $$$. Dont know of any compatible devices for IOS, but maybe if you...