FOR SALE:
Toyota Sunrader RV, 1986 with ~ 113k miles
-4 cylinder
-22RE 1 ton axle rear wheel drive
-Full floating axle
-Custom CD stereo
-Fully converted interior with bathroom, propane stove, refrigerator, 12v fan, etc.
Loves to take trips to Yosemite!
Asking: $11,999 OBO, serious inquires...
I have used working parts from a 100 Series driver side front door for the master switch and the window motor. Take all or one. Asking $160 + shipping for both or $80 ea as separate parts + shipping. Thanks for looking.
I've got a burned out DS window motor. I verified that the switch was not the culprit. The window is fully up or closed. I have a used motor and haven't torn into it yet.
How do I move the window down manually to get the lifter arm out?
Thanks!
I have a used brake booster/ABS/Master Cylinder system from a 2000 Toyota Land Cruiser. It needs to be re-built with seals as the pedal was going to the floor before it was replaced. I saved it hoping someone could use some of the parts and save $$. It is free if you come get it or pay...
FOR SALE:
New in package, from Toyota for 100 series Land Cruiser
QTY: 2
90311-38065 S040 Crank Seal, QTY:2, $5ea
90311-70011 S040 Seal, Type T Oil, QTY:2, $10ea
90311-A0001 S040 Cam Seal, QTY:1 $20ea
$40 for all. I paid over $75. These parts are recommended for the ~90k mile service when...
For Sale:
New and uninstalled, Seat Heaters for front seats, fits 93-97 Toyota Land Cruiser.
Willing to ship. Paid $300.
Best offer around $180 please.
:princess: Keep her happy with a warm booty.
SOLD!!!!!
I've got a used front cv driveshaft for use on a lifted 80 series or good for chopping.
The caveat, one of the u-joints on the CV end is damaged and makes noise.
It was a custom built shaft from SLEE Offroad. Perhaps you can get the details on the parts needed to fix this.
It still...
After trying to install the Roof Top Tent on the roof rack with limited clearance between the roof and the rack, I find it extremely difficult to get to the bolts to loosen or tighten. My arms just will not fit in the 3" space.:crybaby:
What I end of doing is loosening the roof rack and then...
Hi,
I'm looking for a gas can or tire carrier for the Right-Hand Side (Passenger in USA)
I'm planning on retrofitting to make it carry 3 jerry cans as opposed to 1. If you have any of the parts that make this assembly up, please PM me.
Thanks!
I've got five (5) used Goodyear MT/R tires without wheels/rims for sale. They have approx. 50% tread left on them and have been rotated every 5k miles. The sidewalls are in perfect condition and the lugs are all in good shape. I'd like to get $300 for the set of 5. They were purchased at...
I'm looking for the handle that mounts to the 'A' pillar on the driver side of an 80 series. The color must be oak / tan.
Apparently the oak production parts are running scarce and being replaced by a neutral grey. This sucks for those of us with an oak interior! Keep this in mind when...
For the past 3 years I've been running 285/75R16 Goodyear MTRs on the 80. They have 30k miles on them and are starting to hum even louder on the freeway drives.
I'd like to upgrade to 35" tires and possibly try a different tire. What would you all recommend to fit these needs:
Good...
I was following up on scheduled maintenance this evening on the 100. I've got 110k miles on it and the differential fluid was due for a change. This is the second time I've changed it since I owned this vehicle.
After draining the front diff, I went to clean the magnetic plug off and found...
FZJ80 Stock lift / Suspension components
For Sale from a 1997 Toyota Land Cruiser. Parts are STOCK and in perfect condition.
Front & Rear Panhard rods - $100 for both OBO + shipping cost
Front Control Arms with stock bushings - $150 for both OBO + shipping cost
Rear Upper Control Arms...
We're planning a short trip from Joshua Tree over to AZ over Xmas break. The trip will consist of a few days bouldering in Joshua Tree and then driving through Sedona, Flagstaff, and Grand Canyon. Post up any trails that are interesting along the route. Specific camping spots would help too!
From 1997 Toyota Land Cruiser
All original equipment:
- Roof Rack w/ load bars (SOLD)
- Running Boards (SOLD)
- Rear Bumper (Bumper sides, and aluminum plate) (PASSENGER BUMPER SIDE SOLD)
- Rear wind deflector
Just added:
(1) OEM Front Panhard arm
(1) OEM Rear Panhard arm
(2) OEM Rear Upper...
I am in need of the caster plates for 1997 80 Series front control arms. Plans to add the 4" SLEE Springs and I am looking for someone upgrading to the new control arms.
Thanks!
Hey guys,
I've got this air horn (A.K.A Train Horn:grinpimp: ) mounted in the 80 without air running to it.
The project consists of building a small reservoir for air volume capacity (out of PVC pipe and end caps) and plumbing that to the ARB compressor.
What I need help with is...
I have a used Brake Master Cylinder off a 1997 Toyota Land Cruiser 80 series. I replaced it hoping to fix the brakes. The used one is still in fine working condition. I'm asking $50 + shipping. If it is int he Bay Area, CA I can drop it off.
Thanks!