Sold my FJ-62 last year and forgot I had this.
Printed single sided in two 2" binders.
I won't ship it, but you can pick it up in Orange County California.
Cameron
661-238-5234
1989 FJ62 with 177k miles
$4,000
-Converted to 4 speed manual with all parts coming from a FJ60. Original FJ62 T case was kept put converted to all manual.
-Very clean body, no rust. Socal it's whole life.
-A/C converted to R134, blows cold.
-Seats show wear, a few cracks in the dash...
Parts are removed from a 1988 FJ62 with 176K miles. Located at 93561, Tehachapi, CA
4WD solenoid, ONLY ONE WORKS $40
4WD Tcase shifter with all hard and soft lines $100
Auto transmission shifter SOLD
FJ62 nutrual switch $40
FJ62 T case High/Low shifter with very good condition boot $20
FJ62...
I have some sort of an exhaust leak. Sounds like it's coming from one of the back two cylinders. I replaced the exhaust gasket and the leak didn't change at all. I haven't pulled the air injection yet but I don't see any obvious leaks.
The question I have is; If I pull the AI rail should...
This weekend I started the installation of an H42 in my FJ62. I'm using the original transfer case from the FJ62 that's been modified to manual shift. The transmission and bell housing came from a 1984 FJ60.
So far the trans and transfer case have been joined and installed in the cruiser...
I'm installing the trans from an 84 FJ60 in my FJ62. Can someone post a picture of the FJ60 cross member where it attaches to the frame rails? I have the cross member but I would like to see how it's bolted to the frame.
Cam
I have an exhaust leak in my FJ62. Looks like it's the manifold gasket. I've checked the EGR pipe and went around with a tube listening, so I'm pretty sure it's at the gasket at the rear most cylinder. I have the FSM and it looks like a pretty straight forward procedure. Are there any...
I'm working on a trailer hitch at work. Does someone have the distance between the frame rails where the hitch would go, or better yet the distance between the bolt holes.
I'm not going to finish it today, but I wanted to cut the cross piece to length. I'll take all the final dimensions...
I decided to look at fixing the cruise control on my new FJ62 today. I noticed this cotter pin that looked responsible for the cruise control cable breaking. This cotter pin is also damaging the throttle cable. In fact I took a movie with my camera and noticed that the throttle isn't opening...
A few weeks ago I purchased a 1988 FJ62. My girlfriend and I have three dogs and we needed something to haul them around and to go camping in. I use to have a 1993 4Runner, great truck but horrible engine and a little too small.
Overall the FJ62 is in good shape. It has 176K miles. Not a...