I’m replacing the rear hatch on my 80 because of a rear end collision. Got the new one installed but can’t get it fitted properly.
There is too big of a gap at the top when closed, but it rubs when I try to open it. If I move the top back on the hinge it won’t open because of the metal to...
Need a replacement power driver seat for my 96 LX450. I will likely be redoing foam and leather, but if it’s in good shape already even better. I can fix the gears etc. Just need a solid frame with all the motors etc. mine got laid back in a rear and collision.
I am in N East Texas but can...
Was excited to head out to the Toyota Jamboree this weekend only to find out my CDL wasn’t activating. Drove home to work on it and then it started working fine. Went back to trails and it worked for a little bit then stopped again. Then drove home and it worked again.
I went to a buddies...
Lol fair enough. I had disconnected the left side sensor to meter and make sure I was tapping into the correct ports of the four port plug and I forgot to plug it back in.
I’m going crazy trying to get this ABS light sorted.
I jumpered TC E1 and got error code 31.
ohm’d wire to right front and found it to be open.
Replaced the wire and thought it would be sorted.
Now suddenly the ABS light won’t go off at all.
With battery disconnected overnight
With...
Oops hit send too soon. Found that image. And looks like 5 is ground! I’m getting the hang of it now. Thank you so much for your patience helping me out.
Working on that now. But all sockets aren’t labeled. I made another post about it, but some of them clearly go to a IGN+ post. But I’m others, they both go to the connector with no labeling. How to determine which is positive and negative? Other than trial and error taking it in and out of the dash
Thank you for that. So does that likely indicate I’ll need to replace the actuator motor? For some reason it thinks the CDL is engaged when it is not. At least I don’t think it is. I haven’t noticed any issues on tight turns. I’m going to use the ‘Jack the front tire up and see if it spins in...
You’re awesome! I’ll dig in tomorrow and see if I can narrow this problem down. Although today I figured out that my bulb for the center diff lock was out and when I replaced it, it was permanently on. So there’s an issue with the center diff lock that may be causing the ABS problem.