1988 toyota V6 pickup
I need to read my codes. I know where to jump, I've done it before but this time I get no response.
The computer has a code while running but when I shut it off and jump the terminals, the check engine light doesn't blink- it just stays light. What could be the problem?
running without a knock sensor?
I cant get my knock sensor to give a reading to the ECU. Short of running another cable from the knock sensor to the ECU.... I want to disconnect the sensor.
That being said... the knock sensor retards the timing when there is a short or open circuit... I read 5...
Ok, the whole reason I'm doing all this work to my truck in the first place is that when the brakes are applied, the idle pulsates. When sitting there in teh driveway by itself it'll idle fine. Its only when I step on the brakes that the irradic idle will show itself... Anyone have any ideas???
Ok, I adjusted my TPS correctly and hit all the desired ranges with the ohm meter... The truck idles good but when revved, it hangs a bit on the down side. Better...
Now the truck is coming up with a CODE 52 which is the knock sensor, ECU... I swapped an ECU out and still the same... Two...
I have an 88 pickup with a v6 motor. The problem is that it starts right up but idles in waves.. high then low. When I step on the gas it wont rev and has small bafires in the intake. I got a code to the TPS but the TPS checked good and even switched it with another working trucks TPS. When the...