To anyone interested, I took it for a good drive and decided that since I'd used two MAP sensors it was probably the fuel cut coming on and off. Its automatic diesel pump.
Bought a budget $20 boost gauge and sure enough straight to 15psi under any load.
Removed the heat shield etc to access...
Hello,
I have a 4Runner / Surf 1KZTE which is showing fault code 35 for MAP sensor. I have replaced the sensor off another running vehicle to test, and the same issue still persists. I've checked the small filter and the hole in the intake manifold and neither are blocked.
When under heavy...
Hi all,
Sorry for the lack of reply, finally had a chance to remove the motor this weekend...
We found that the rear main seal was in fact, in tact, and the leak had come from the rubber sump seal which had split at the rear of the engine. We torqued the sump down far too hard which caused the...
Hi all,
I have just put together a new 2LT engine (reconditioned block & crank, new head, valves, pistons etc) and I have some massive blow by. The engine ran well despite, but made it less than 500km before blowing out the rear main oil seal from the pressure. The block and head were each...