Search results for query: *

  • Users: Wot91
  • Content: Threads
  • Order by date

Forum search Google search

  1. W

    What is this?

    I have two FJ 40‘s Built in 1977 one has a windshield washer squirter and the other one has this white button. The washer squirter hood has a bigger hole. This white button only has a hole in the part that goes through the hood but no air comes out of it. The one hood that has this white piece...
  2. W

    Floor pans

    I ordered some motor city metal work floor pans for the life of me I can’t help figure out how the passenger side goes in
  3. W

    Min truck steer box ?

    Min truck steer box fitting size? The info I am finding is 17 MMI x 1.5 and 16 MM x 1.5 for any of the fittings I find have an o ring on the end. Sorry if this is already been discussed
  4. W

    Wanted  1978 Fj40 ny min Conversion

    Pedestal for min steer box conversion 1978 Fj40
  5. W

    Thoughts and ideas 78 Fj40

    Cleaning the ID plate for the shift pattern on the glove box. Would like to polish the aluminum without removing the paint
  6. W

    Parting Out  Ny parting out 78! Fj40

    Parts are going fast because they are going cheap. what do you need? Pm me
  7. W

    Need help ID this part. 1978 FJ 40

    Need help ID this part. 1978 FJ 40
  8. W

    Parting Out  Ny. October 1977 so 78 model 40

    Manual steering heat shield Carburetor cooling fan Cooling fan control box Emissions control box Doors Front seats with head rest Heater cores And Lots of other parts just ask
  9. W

    Parting Out  Northern New York 1978 fj40

    Build date October 1977 so it’s 78 model. Looking to sell or trade parts enough to see if I can get this one running. I trade for carburetor, electronic distributor. I have sunvisors, front seats, glove box door, ashtray, grab bar for passenger, vacuum switching box, carburetor cooling fan...
  10. W

    Anybody put Holley EFI on an F2 and regret it?

    Would you install Holley Efi on a f2 again? what is the cost worth it
  11. W

    1978 FJ 40 steps/rock sliders

    1978 FJ 40 steps/rock sliders thinking about building step/rock sliders I picked up some 6“ x 2“ tube and started mocking it up. I have some more trimming to do. Thanking about going all the way to the wheel arch in the rear. Leaving in about 1/2 out from the body a quarter inch from the...
  12. W

    Anybody above Syracuse New York on here?

    Looking For locals to get information and ideas and parts
  13. W

    1977 FJ 40 oil pan gasket

    I have bought a four piece cork Fel-Pro gaskets it which is going to be easier installing it on the block or installing it on the oil pan first. I am worried about the cork not sitting in the crank saddle right. PS I’m doing this in chassis
  14. W

    1977 oil pan bolts

    Pull the oil pan through all the bolts in the bucket after cleaning them I noticed four of them were shorter than the rest. Is this normal? Do the shorter ones just go in the corners Before
  15. W

    With this truck have the steering box and pump I need for swap

    Would vin JT4RN50R8G0151926 Have a solid straight axle in the front
  16. W

    77 FJ 40 looking for a part number

    77 FJ 40 looking for a part number for the carburetor mounting gasket Stock carburetor
  17. W

    1977 Fj40 need a part number

    Looking for a part number for three wire voltage regulator I can get at local parts store Mech. Or ss aftermarket is fine. Need to get it up and roll before the next snow storm
  18. W

    1977 vr

    Where to get cheap voltage regulator three wire. I don’t care if it’s mechanical or solid state
  19. W

    1977 FJ 40 one wire alternator

    Thinking about getting rid of this X ternal voltage regulator in the alternator set up. What one wire alternator should I use. What make in year vehicle should I tell the parts guy
  20. W

    1977 FJ 40 will these rims fit

    1977 FJ 40 will these rims fit off a 1995 t100
Back
Top Bottom